New watch strap to buy the world is too long, how to shorten it? Today , Feng Feng just to share with you how to use the watch to adjust the world watch strap length, go and see!
Step / method one:
1, the handle of the bezel unscrew the thimble back to the side of the flat shape!
2, aimed at the demolition of the world watch strap strap between the small card, the handle of the bezel screwed on and eject the small card pin can be.
3, the world watch strap into the bezel of the "grooved" (two steel pins with a flat head is a word Slit one word there is a card slot so the spike from one end of the flat top Can not enter from the top of a font)
4, adjusted to the appropriate length according to the size of the wrist, and then press the arrow in the opposite direction to put the needle back, put the world watch strap but watch the world watch strap must first determine the world watch strap is not gong wire but by Nail or hairpin loaded. From the small mouth at the top of the mouth that is OK! Hard to dismantle the strap can only be less than a minute when you can get!
Precautions
Imitate the thimble must be aligned with the watch of the watch band in the world, otherwise it is necessary to adjust the watch top bad.
Spread the watchmaker to avoid twisting force inside, otherwise it may lead to meter scrapped.
Meter using steps / methods II
General world watches when the strap is long. When you get a new world watch, the first step is to adjust the strap length and size. The most commonly used meter transfer tool is the meter, and hammer, the following is the use of the meter:
1, the direction of the world watch chain. Prepare to dismantle the strap before you carefully see the arrow on the back of the strap, the general world watch the downward direction of the chain is the next big small, the strap into the slot in the meter, according to the arrow, align the world Watch chain Bangzi Confucius Confucius direction.
2, remove the nail table. Loosen the bezel handle, place the strap in the watch's face, and hold the bezel of the bezel to the pinhole of the strap, gently tighten it, and the pin connecting the strap will be ejected. If it is the world watch strap longer, it is recommended to remove the same number of sections on both sides of the bracelet to ensure the balance when worn watch .
3, reload nails. The world watch strap strapped to the appropriate wrist size, the first disconnect the two straps together, did not go in the second step and then press the top of the pin or hit with a hammer! Note: When reassembling the strap, it should be inserted in the steel needle is best in the opposite direction of the arrow, and is an advanced selection of needle day, it will be easier to load).
Precautions
Reinstall the watch nails, the world watch strap demolished to the size of the appropriate wrist, the first disconnect the two world watch strap connected to the part did not go according to the second step of the method of pin into or With a hammer percussion can be.
Poly fashion watch network Recommended reading:
Quartz watch is good or mechanical watch good ladies watch brand list the world's top ten watch brand watch list